Ebode IP Vision 58 Manual do Utilizador descarregar pdf (Página 33)

Manual version 1 – March 2012 33 IP Vision 58

3.2 Network Settings

Click Network, will pop-up the prompt as below:

Figure5.7

3.3 Basic Network Settings

Here you can fix the camera’s IP address; means set the static IP address of camera manually.

You can also do the same settings from IP Camera Tool. (Figure 2.3)

There are some good reasons to give the camera a static IP. The factory default setting is DHCP, this means

that the network router will give the Camera an IP address itself for easy setup. The problem is that after a

camera or network power loss the router may decide to give the camera a different IP address than the last

time. If you want to login to the camera not using the IP Tool you don`t know the camera`s (new) IP address.

Figure 5.8

If you don’t know Subnet Mask, Gateway, DNS Server. Please check the Local Area Connection Status of

your computer; it contains all these information, steps as below:

1. Control PanelÎNetwork ConnectionsÎLocal Area ConnectionsÎ Support Î Details

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 76 77

Sem comentários

Ebode IP Vision 58 Manual do Utilizador Página 33