Ebode IPV68 Manual do Utilizador descarregar pdf (Página 7)

March 2013 IPV68

1.5 Hardware Installation

You need to set up your camera using a network cable (wired) first, before you can use it wirelessly, so

let’s start with plugging in the network cable. Follow the steps below to set up your camera hardware.

1. Plug one end of the network cable into the camera, and the other end into an empty port of your

router/switch/modem.

2. Install the Wi-Fi antenna.

3. Plug the power adaptor into the camera and into an AC outlet.

4. It takes approximately 30 seconds to boot up the camera.

5. When the power is on and the network cable is connected, the green LED on the rear panel next to the

network cable will stay on, please make sure the Green light is on before we continue.

The yellow LED will keep flashing, and the Indicator LED on the front of the camera will flash when the

connection is established. (The behavior of the front indicator LED can be controlled by software).

Figure 1.4

1.6 Software Installation

1. IP Camera Tool: Insert the CD, a popup menu might appear like shown in the picture below.

2. Select “Open Map” and click “OK”

1 2 3 4 5 6 7 8 9 10 11 12 ... 75 76

Sem comentários

Ebode IPV68 Manual do Utilizador Página 7