Ebode EMML Guia do Utilizador descarregar pdf (Página 7)

Transmitter - Micro Remote Control Module Ref : EMML

July 2009 page 7 EMML

PROGRAMMING

In order to add the Micro Transmitter to a different installation from

the original one, or to one with interference from a nearby system,

it is necessary to program a different code.

The programming address is made up of a ”HOUSE” code (from A through P) and

a “UNIT” code (from 1 through 16). The factory default address of the transmitter/

receiver pair is set at A1; proceed as follows to set a different code.

A. Accessing programming mode.

- Press the Micro Transmitter’s START (1) and STOP (0) buttons briey and

simultaneously. The LED turns YELLOW.

Then the LED lights up RED once (for the HOUSE CODE), then GREEN once (for

the UNIT code). The Micro Transmitter is in the A-1 setting.

You have 6 seconds to program a new code.

B. Setting the HOUSE CODE.

- Press the (1) button as many times as needed to get to the desired HOUSE

CODE and then release it.

Example: A = Press once, B = Press twice, C = Press three times, ... P = Press

16 times.

- After having set the HOUSE CODE, the LED will ash YELLOW 3 times to conrm

the code has been memorized and exit from programming mode.

C. Set the UNIT CODE.

- Repeat step A only.

- Press and release the (0) button as many times as needed to get to the desired

UNIT CODE and then release it.

Example: 1 = Press once, 2 = Press twice, 3 = Press 3 times... 16 = Press 16

times.

- After having set the UNIT code, the LED will ash YELLOW 3 times.

VERIFICATION

Let the Micro Transmitter be recognized by the receivers.

Verify On/Off switch operation.

You must wait about a second between each On / Off command.

When changing the battery, the registered code will be retained by the Micro

Transmitter.

Troubleshooting - please check FAQ and technical support on

www.ebodeelectronics.eu

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Sem comentários

Ebode EMML Guia do Utilizador Página 7