Ebode PMML Guia do Utilizador descarregar pdf (Página 6)

Transmitter & Receiver - Remote Controlled Appliance Kit Ref : PMML

July 2009 page 6 PMML

INTRODUCTION

The MICRO MODULE PACK allows the installation of a wireless

controller for incandescent, halogen, low-voltage, energy-saving or

LED light xtures.

• Without the need to run wires, the Micro-Module Pack allows you to place a

switch where you choose.

• It integrates with existing switches eliminating the need of running new wires

or cutting extra holes in the wall.

• It installs in just minutes.

• It’s compatible with all ebode home automation devices. For more informa-

tion, visit the site www.ebodeelectronics.eu.

DESCRIPTION

1.1 EMML Wireless Micro Transmitter

LED indicator

(1) For switching on/programming

(0) For switching off/programming

1.2 RMML Micro-Receiver

LED indicator

(PROG) for programming or (RESET)

INSTALLATION

2.1 EMML INSTALLATION OF THE MICRO TRANSMITTER

1. Cut out a 65 mm hole 40 mm deep with a hole saw.

2. Set the insert box in the wall .

3. Remove the battery’s protective tab then press the

buttons to test. Pressing the (0) lights the red panel light.

Pressing the (1) lights the green panel light.

4. Connect the Micro Transmitter’s wires to the switch (see

opposite diagram)

5. Place the Micro Transmitter and the switch in the insert

box taking care to pull out the antenna as much as you can.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Sem comentários

Ebode PMML Guia do Utilizador Página 6