Ebode PMML Guia do Utilizador descarregar pdf (Página 8)

Transmitter & Receiver - Remote Controlled Appliance Kit Ref : PMML

July 2009 page 8 PMML

UPGRADING AND PROGRAMMING

If you wish to add other Micro Transmitters, Micro Receivers or re-

mote control switches to the existing installation, you may choose

among the following solutions:

-Add one or many command points to create a two-way switch: Install the

Micro Transmitter(s) as specied in its manual

-Add a remote control switch: The rst line of buttons automatically controls the

lighting. (See remote control switch manual).

-Add an additional lighting spot: Install the Micro Receiver as specied in its

manual.

REMARKS

Within a single installation, no additional programming is necessary to add one

or more Micro Module(s) and remote control switch(es) to this pack.

-Installing an additional pack for another lighting point: In order to separate the

two installations, follow these instructions.

3.1 HOW TO PROGRAM THE MICRO TRANSMITTER

In order to add the Micro Transmitter to a different installation from the original

one, or to one with interference from a nearby system, it is necessary to pro-

gram a different code.

The programming address is made up of a ”HOUSE” code (from A through P)

and of a “UNIT” code (from 1 through 16). The factory default address of the

transmitter/receiver pair is set at A1. Proceed as follows to set a different code.

A. Accessing programming mode.

- Press the Micro Transmitter’s START (1) and STOP (0) buttons briey and

simultaneously. The LED turns YELLOW.

Then the LED lights up RED once (for the HOUSE CODE), then GREEN once (for

the UNIT code). The Micro Transmitter is in the A-1 setting.

You have 6 seconds to program a new code.

B. Setting the HOUSE CODE.

- Press the (1) button as many times as needed to get to the desired HOUSE

CODE and then release it.

Example: A = press once, B = press twice, C = press three times, ... P = press

16 times.

- After having set the HOUSE CODE, the LED will ash YELLOW 3 times to

conrm the code has been memorized and exit from programming mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Sem comentários

Ebode PMML Guia do Utilizador Página 8